And as I learned from the manual, Videohub control should see the unit even when connected through USB only. Using "add videohub Control" by typing the IP number (as showed in server preferences) is not working. Remote Videohub and Videohub Control are not working over network. The one exception is the Videohub CleanSwitch, where there are frame synchronizers on every input for this purpose. Blackmagic Design VHUBSMAS12G2020 Videohub 12G 1RU 20x20 Zero. The Reference input on all VideoHubs (one exception) controls when the switch happens vertically between inputs. Remote Videohub stops working when USB cable is disconnected, though connected over the Network. See Blackmagic Design BMD-VHUB/VM Manual/Specs (PDF). Remote Videohub is working fine, as long as the USB link is used. Subnet, gateway and Mac Address are fine, so in theory it's all there to make it work. Videohub Server preferences shows that the unit has gotten an IP through DHCP. The remote Videohub soft (V 4.9.4) is working fine when connected through USB link.Įven with the unit linked through USB, Control Utility doesn't see the unit. The software however (VideoHub Control Utility) is not seeing the VideoHub. Blackmagic Videohub 20x20 12G is an advanced zero latency video router that supports any combination of SD, HD and Ultra HD on the router at the same time. For example Input 1 on the MV4 is Input 3 on the ATEM, etc." In an IP world, it seems like this would be SO easy to program, and would be so incredibly useful across the Multiview 4 and the Multiview 16.I have installed a Smart Videohub, of which the hardware is working fine. Why can't I go into the software and somehow say "hey Multiview 4, talk to the ATEM at this IP address to get tally info, and even further, map inputs on the Multiview 4 to specific ATEM inputs that might or might not match. But he can't, because these are fed from a Videohub, and we need all 4 inputs for cameras. The 80 12G-SDI inputs feature LEDs on each BNC that indicate an SDI signal, plus there are 80 12G-SDI outputs, redundant power and reference connections in a stylish four rack unit design. It would be even better if he could have tally. Blackmagic Videohub 80x80 12G is an advanced zero latency video router that supports any combination of SD, HD and Ultra HD on the router at the same time. We have a Multiview 4 connected to a 4K display for the robocam operator. Features control panel, re-clocking and external Ethernet control. Here is a scenario that illustrates what I mean better.We run a lot of corporate all hands meetings with 4 robo cams and 1 manned camera. Medium 20x20 model zero latency 12G-SDI video router supports any combination of SD, HD and Ultra HD on the router at the same time. Why do I still need to eat up SDI inputs and rely on SDI signal to transmit tally data? And why isn't it more flexible? Why does tally data still feel so restricted and so dumb?Īll of this equipment is connected over IP. WE have an ATEM 2M/E Broadcast Studio, (1) 40x40 Smart Videohub, (1) 20x20 Smart Videohub, (2) Multiview 16s, and (1) Multiview 4. We have leaned heavily into the BMD universe of equipment for our life setup. Tally is one of my biggest frustrations with the BMD universe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |